Remix of the motorcycle license frame that includes a GoPro style mount for cameras. This was remixed with the California license plate in mind, so there may be some incompatibles for other regions.

Included is a file for a top mount and another for a bottom mount. The difference between them is whether you want the mount to be at the top or to be at the bottom of the frame.

I have rode a few miles with this on and not had any issues. The screw holes were a bit of a tight fit, but they did go in after some loosening and re-tightening. My advice is to leave the screw(s) loose until all screws have been somewhat screwed in and then tighten everything. The print just needs an adjustment to be extended a little bit, but I have not done all the measurements to determine how much extension is needed for a more comfortable fit.

The frame pictured was printed in a washable green resin on my SLA printer, but I am sure that this can be printed with FDM printers with no issues. I just prefer the look and feel of SLA.

Do note that I have only printed and tested the bottom mount and that is what is shown in the pictures from my motorcycle. I have not printed and tested the top mount frame.