This thing was designed by "Vanny" and from me printed but not tested in flight .
After maiden flight as a glider I will use it.
When using Slic3r please scale to 1000%.
A 35mm brushless outrunner fits well.
The outer diameter of the firewall will be 40 mm.
Please turn parts in best position before printing.
Use ca-glue and activator spray to put parts together.
Sand a little if surfaces are not flat.
| printaufsatz4mm.stl | 8.5MB | |
| printcoverring.stl | 2.6MB | |
| printdeckel.stl | 3.4MB | |
| printgondel.stl | 14.4MB | |
| printlasche_deckel.stl | 4.9MB | |
| printschaft.stl | 4.3MB | |
| printschuh4mmmitLoch.stl | 2.0MB | |
| print_spinner_Bodenplatte.stl | 2.1MB | |
| print_spinner_oben.stl | 3.8MB | |
| spange.stl | 349.5KB |
