The spool holder that came with my monoprice maker select v2 was too small to hold the spool I also got from monoprice... so I designed one that's properly sized. Bolts on with the original nut.
STL for the nut, in case you lost the original: https://www.thingiverse.com/thing:2333352
Older design, v1: http://www.thingiverse.com/thing:1791166
Changes from v1: thinned down the tip of the holder from 45mm to 25mm, thinned down the bulk of the length from 37mm to 20mm, aside from the last 10mm which bevels from the 20mm diameter to 37mm so the holder still bolts to the frame securely. The bevel also keeps the overhang angle slightly below 45 degrees, so it can still be printed without supports.
| MPMSBSHv2.stl | 2.0MB |
