Monitor Stand 3D Printer Model
The file 'Monitor Stand 3D Printer Model' is (STL) file type, size is 5.7MB.
The file 'Monitor Stand 3D Printer Model' is (STL) file type, size is 5.7MB.
A four part monitor stand meant to hold a 24 in monitor. Monitor Tilt is adjustable. If anyone wants a different height, there is a model attached with different height positions for the Vesa Mount. You need 350mm of print height, and a 300mm^ bed to print the base in one piece. If you use this model please consider donating.
This base was printed with a 0.8mm nozzle, two outer layers, and 0.25mm layer height. Infill was 50% with a triangular pattern.
The bolt and grapel were printed with a 0.4mm nozzle, five outer layers, and 0.2mm layer height. Infill was 70% with a triangular pattern.
The Vesa mount was printed with a 0.4mm nozzle, 3 outer layers, and 0.2mm layer height. Infill was 50% with a triangular pattern.
If you intend to use this part make sure you are using high quality filament, and at minimum, the settings I used about, if not more. With my filament, the stand was able to hold 20lbs for 15 minutes without a problem.
If you would like help with your project, please see my website.
www.bitdrafted.com
| MonitorStand_Base2_HeightAdj.STL | 4.8MB | |
| PortraitMonitorStand_Base2.STL | 3.4MB | |
| PortraitStand_Bolt.STL | 1.4MB | |
| PortraitStand_Grapel.STL | 3.3MB | |
| PortraitStand_VesaMount.STL | 832.6KB |
