Modular design approach to a stackable andon light using commonly available flexible WS2812 (or similar) LED strips. LED spacing is 16 mm.
Module diameter is ~50 mm and height is ~
I made this design a while ago but didn't think it was ready enough for uploading.
There are some tight tolerances especially in the LED strip holders making up the center pillar everything rests on. A better approach may be to simply use a PCB with similar dimensions instead of fiddling the LED strips into a long center pillar.
To save a lot of time and retracts, print the diffusers with 0 % infill. The walls are so thin, that no infill is actually necessary.
One method to drive the LEDs is with WLED, by grouping the LEDs accordingly into lighting segments.
| Bottom_Cap.stl | 189.9KB | |
| Center_Piece.stl | 9.5KB | |
| Diffuser_Piece.stl | 1.5MB | |
| Inbetween_Cap.stl | 328.2KB | |
| Top_Cap.stl | 196.4KB |
