Modular Shelf – Stackable And Hold Up To 50 Pounds 3D Printer Model
The file 'Modular Shelf – Stackable And Hold Up To 50 Pounds 3D Printer Model' is (stl) file type, size is 60.6KB.
The file 'Modular Shelf – Stackable And Hold Up To 50 Pounds 3D Printer Model' is (stl) file type, size is 60.6KB.
Suggested Print Setting
Support - On Buildplate Only
Infill - 25%
Layer - .28mm, really doesn't matter
This is for a series of legs to build your own shelf. In addition to printing it out, you will need a board that measure .75 inches thick, the length and width of the board is entirely up to you.
There are three shelves avaiable here
the one marked s200mm are stackable and is 200 mm tall.
-s200mm1 is used for the first story of the shelf, s200mm2 is used for the second story and up, s200mm3 is used for the final story, to cap it off. So if you only want a 2 story tall shelf, use s200mm1, and s200mm3 only
The one marked s250mm are also stacable and it is 250 mm tall. The insturction is the same as the 200mm one
I also include a file called wall anchor in case you want to secured it to the wall. Which I highly suggested
Which ever size and version you decided, just make sure you print 4 of the same leg per story.
| 2s250mm-2_stories_250_mm_leg_-_need_support.stl | 33.6KB | |
| bottom_bracket.stl | 3.4KB | |
| s200mm2-stackable_2_stories_200_mm_leg_-_need_support_-_use_for_2nd_story_and_up.stl | 34.6KB | |
| s200mm3-stackable_2_stories_200_mm_leg_-_need_support_-_use_for_top_and_last_floor.stl | 32.4KB | |
| s200mm_-_stackable_2_stories_200_mm_leg_-_need_support_-_use_for_1st_story.stl | 34.4KB | |
| s250mm1-stackable_2_stories_250_mm_leg_-_need_support_-_use_for_1st_story.stl | 33.8KB | |
| s250mm2-stackable_2_stories_250_mm_leg_-_need_support_-_use_for_2nd_story_and_up.stl | 36.1KB | |
| s250mm3-stackable_2_stories_250_mm_leg_-_need_support_-_use_for_top_and_final_floor.stl | 33.7KB | |
| ss200mm_-_single_story_200_mm_leg.stl | 32.1KB | |
| ss250mm_-_single_story_250_mm_leg.stl | 28.9KB | |
| wall_anchor.stl | 54.2KB |
