As a maker without a makerspace, my room was a mess. I made these shelf brackets to help clear up my work surfaces and organize things a bit.
Just print the brackets and slide a 1x2 board in for a snug fit. I've also included files for boards, if you'd rather print them too.
Command strip mounted, so you can use more or less brackets for extra support. I suggest 3lb or 5lb command strips.
Each piece should be printed on the side, except the boxes which should be printed upright.
| 100mmplank.stl | 88.9KB | |
| 200mmplank.stl | 173.3KB | |
| 280mmplank.stl | 238.9KB | |
| 30x132-flatbox.stl | 700.3KB | |
| 380mmplank.stl | 323.3KB | |
| 40x40-smallbox.stl | 557.5KB | |
| 480mmplank.stl | 404.6KB | |
| 52x80-fatbox.stl | 712.8KB | |
| 60x60-mediumbox.stl | 735.8KB | |
| 92x80-largebox.stl | 731.5KB | |
| Double_-_Endcap.stl | 843.6KB | |
| Double_-_Hook.stl | 695.8KB | |
| Double_-_Thin-Open.stl | 926.0KB | |
| Double_-_Thin.stl | 879.9KB | |
| Double_-_Wide-Open.stl | 983.8KB | |
| Double_-_Wide.stl | 922.8KB | |
| Single_-_BoxHanger.stl | 678.2KB | |
| Single_-_EndCap.stl | 596.2KB | |
| Single_-_MagnetClip.stl | 708.4KB | |
| Single_-_RoundHook.stl | 659.1KB | |
| Single_-_SmallHook.stl | 569.4KB | |
| Single_-_TapeHolder.stl | 1.1MB | |
| Single_-_Thin-Open.stl | 455.0KB | |
| Single_-_Thin.stl | 721.0KB | |
| Single_-_Wide.stl | 756.0KB |
