This is a modular sewing spool holder system that uses tileable snap-together bases and snap-in pegs.
The snap-in peg design provides some neat advantages:
The bases also snap together and can be tiled - the 4x4 and 5x5 grids have the same outside dimensions, so you can mix and match in a grid (see pics). I am working on additional bases for larger spools but they are not yet perfected.
Optionally print a small peg and base for calibration, choose and print the appropriate base for your sewing spool size, then choose your peg length and print the corresponding number of pegs.
The 66.5mm pegs should be just long enough to hold a standard height spool and its bobbin. However, if you put this in a drawer, you'll find that every time you close the drawer with any force, your bobbins go flying off the top of the pegs.
The pegs are wider at the base to better fit a spool, and taper slightly towards the top until the last few cm, where the diameter is small enough to hold a bobbin.
The tallest peg height was selected to just fit inside smaller IKEA LINNMON drawers (this is the type of drawer shown in the pictures).
DesignSpark mechanical source files are included if you want to make shorter pegs. Don't try to scale the pegs with your slicer as it will mess up the proportions of the snap-in part of the peg.
(Shameless plug alert) A great accessory for this Thing is the Improved Sewing Bobbin Clip - clipped bobbins fit on top of the spools. You can see some of these in the pics.
Base_-_4x4_27mm_spools.rsdoc | 3.9MB | |
Base_-_4x4_27mm_spools.stl | 7.5MB | |
Base_-_5x5_19mm_spools.rsdoc | 4.8MB | |
Base_-_5x5_19mm_spools.stl | 2.6MB | |
Base_-_Snap-in_Calibration.stl | 446.4KB | |
Peg_-_66.5mm.rsdoc | 262.2KB | |
Peg_-_66.5mm.stl | 701.4KB | |
Peg_-_81.5mm.rsdoc | 235.2KB | |
Peg_-_81.5mm.stl | 700.7KB |