Modular Sci-Fi Colony Building (for 15mm) 3D Printer Model
The file 'Modular Sci-Fi Colony Building (for 15mm) 3D Printer Model' is (stl) file type, size is 270.6KB.
The file 'Modular Sci-Fi Colony Building (for 15mm) 3D Printer Model' is (stl) file type, size is 270.6KB.
Updated 13/04/21: - Added water tower.
Stackable/modular buildings for tabletop gaming, scaled to suit 15mm miniatures. Intended to be used as sci-fi colony housing/storage units/labs, etc.
The doors can be positioned however you prefer, either glued or left loose. The notches to allow it to hinge do not work very well, but it should stay where you put it. This may be improved in a future version.
These all seem to print fine without supports:
(Figures shown in the images are poor prints of excellent models by Arian Croft - https://www.thingiverse.com/dutchmogul/designs)
| Colony_module_-_aircon.stl | 6.3KB | |
| Colony_module_-_balcony_floor.stl | 138.8KB | |
| Colony_module_-_door.stl | 77.6KB | |
| Colony_module_-_ground_floor.stl | 142.1KB | |
| Colony_module_-_parapet.stl | 12.4KB | |
| Colony_module_-_railing.stl | 173.7KB | |
| Colony_module_-_roof.stl | 46.3KB | |
| Colony_module_-_upper_floor.stl | 248.0KB | |
| Colony_stairs.stl | 50.2KB | |
| Colony_water_tower.stl | 153.0KB |
