A playmobil sized castle/guard tower.
For the ground floor I used the stable from https://www.thingiverse.com/thing:3736545 The roof of this stable will also fit if you don't want to use the battlements.
There is a choice of printing with floor directly attached or printing walls and floor separately. This is because my prints would often fail when the print was half way done, but this turned out to be some problem with the grey filament I was using, so I continued with green.
I still have to design stairs to the top floor through the hole.
I printed with a resolution of 0.3 mm.
| Battlements_no_floor.stl | 8.1MB | |
| Battlements_with_floor.stl | 9.0MB | |
| Floor.stl | 886.5KB | |
| Floor_with_manhole.stl | 934.5KB | |
| Room_no_floor.stl | 10.4MB | |
| Room_with_floor.stl | 11.0MB | |
| Stairs.stl | 140.3KB |
