i made this for peppers so I didn't need to switch pots or risk killing them while transplanting them and thought it would be cool to upload it here
the bottom can be printed thinner on the z axis if you want its just support/water overflow
you are going to want to print a second closer part to add a new mid/top part one to act as a temp pot bottom until you have your new mid/top setup to place the one acting as the top on top of then you can remove the first one that you initially had as the bottom of your pot and close it off with the hole closer
you might want to use infill to make it feel more sturdy
I have also made a fully customizable plant support module for this pot if you wish to check it out
resize it to your plant needs I have it printed quite big as my peppers cant survive out doors so I'm trying to make a permanent solution
| bottom1.2.stl |
| previous-module-filler.stl |
| top-mid-closerV1.2.stl |
| top-or-midv1.2.stl |
