Modular NodeMCU Relay Controller 3D Printer Model
The file 'Modular NodeMCU Relay Controller 3D Printer Model' is (3mf,stl) file type, size is 3.5MB.
The file 'Modular NodeMCU Relay Controller 3D Printer Model' is (3mf,stl) file type, size is 3.5MB.
I needed an all in one box to control and monitor multiple things. I have this box controlling 2 LED panels in garage (Bay1, Bay2), PIR sensor in the front of the garage, Reed Contact Switch to indicate if garage is open/closed, LED panel over my workbench, and LED Strips that shine down on the front of garage door. All from a single NodeMCU running Tasmota Firmware.
I started with a relay box from wickwire and an NodeMCU mount from Boltz. Added my own modular component bays with relay enclosures. There is a spot for a dRok voltage regulator I ended up not using, and also a block on the back I melted two wire screw down posts into. All high voltage is walled off and seperated from the low voltage components. Used 3d Builder from Microsoft! :p (I hear you giggling)
| garageController_Base.3mf | 439.3KB | |
| garageController_Base.stl | 4.4MB | |
| garageController_case.3mf | 545.8KB | |
| garageController_case.stl | 125.4KB | |
| garageController_FullBuild.3mf | 943.9KB | |
| garageController_Lid.stl | 357.1KB | |
| garageController_NodeMcuLid.stl | 2.0MB | |
| garageController_relay.3mf | 17.1KB | |
| garageController_relay.stl | 18.1KB |
