The file 'Modular Enclosure Compatible W/ CM4-NANO-B Base Board For Raspberry Pi Compute Module 4 3D Printer Model' is (3mf,scad,stl) file type, size is 347.1KB.
This is a mirror of Modular enclosure compatible w/ CM4-NANO-B Base Board for Raspberry Pi Compute Module 4 on Printables by @Markus_55000. As much as possible from that part has been copied/reproduced here.
The original description follows:
WaveShare makes a really attractive and very compact base board for the Raspberry Pi Compute Module 4 (CM4). Unfortunately, when I bought mine, there were no suitable enclosures available. This model addresses that shortcoming.
This is a compact screw-less design. The baseboard and CM4 tightly fit into the enclosure, and the enclosure slides together.
There are optional mounting tabs that can be snapped off, if not needed. The holes are compatible with 19" racks.
The antenna mount is an optional component that can be snapped onto either the right or left side with the antenna sticking out either to the top or bottom.
Print in PLA or PETG with the standard 0.4mm nozzle. The walls are intentionally kept thin, so that the case remains flexible. This helps when fitting the components into the enclosure.
There are vent holes on all sides, and a small heat sink could probably be attached to the compute module. But there is no provision for active cooling.
The original work is published under the CC-BY-4.0 license.
| nanocase.3mf | 196.2KB | |
| nanocase.scad | 5.5KB | |
| nanocase.stl | 941.1KB |
