This initiative tracker is modular and can be extended to be as short or long as you like. I created tokens for all basic DnD classes as well as a monster token.
Some of the tokens are indicated as "invalid" models in my slicer, even though they are fusion 360 exports and should be fine, but all of them sliced without any issues.
I suggest using a 0.2mm nozzle to get the full detail on the more intricate tokens, like Sorcerer or Fighter.
Other than that there Is no special overhangs or any kind of tight tolerances, so they should print nicely.
If you want multicolored tokens like I did, you need to swap filament at 2.5mm height and 4mm height.
| BarbCoin.stl | 1.9MB | |
| BardCoin.stl | 47.7MB | |
| ClericCoin.stl | 2.4MB | |
| DruidCoin.stl | 556.7KB | |
| FigCoin.stl | 5.5MB | |
| InitiativeTracker.stl | 247.3KB | |
| LockCoin.stl | 6.4MB | |
| MonkCoin.stl | 2.0MB | |
| MonstCoin.stl | 521.7KB | |
| PalaCoin.stl | 1.2MB | |
| RangCoin.stl | 3.9MB | |
| RogueCoin.stl | 768.3KB | |
| SorcCoin.stl | 2.0MB | |
| WizardCoin.stl | 14.7MB |
