Welcome to the world of PrintBrick Modular Dioramas. PrintBrick is a diorama building system developed by me, Joe’s Joes (https://www.facebook.com/JoesGIJoes) for 6” action figures. It uses 3d printed wall sections which are connected together with Logo* Technic pin or connectors. These connectors allow the friction power needed to hold the pieces together without glue. No glue means that it is completely modular. Build it one way today, tear it apart and build it a different way tomorrow. My set options are only suggestions as to how the pieces could be used in a building system. There are no limitations as to how far you could take it.

*We cannot use the popular name brand of this popular building brick system, so we are going to call it Logo instead. You can replace the first "o" with an "e" and that is the name brand we are referring to.

This set includes the following pieces:
• Brick Wall.stl
• Corner.stl
• Brick Post.stl
• Brick Post Backing.stl
• Brick Wall Width Addon Single (These pieces allow you to fine tune the length of your project so that it will fit in shelves)
• Brick Wall Width Addon Double
• Brick Wall Width Addon Triple

To build the set in the picture you will need:
• Brick Wall x8
• Corner x2
• Brick Post x3
• Brick Post Backing x3
• Some glue to connect the Post Backing to the Post
• 24 Logo Technic Pins (see included PDF as to where to find them)

But please build this however you want. My hope in bringing this set to the action figure community is that it will allow all sorts of new creativity utilizing the system. If you have ideas, please don’t hesitate to bring them to me by sending me a message on my Facebook Page (link above)

I chose to not charge for this set in the hopes that you will see the potential of the system. I have other exciting projects that utilize many of the same pieces in this set . My other sets have a small cost associated with them and can be found on Cults 3D.