A modular dice box stand display to store and organize your dice boxes. I made it for the Chessex dice boxes.
The smaller size fits 9 dice boxes, but it can be expanded to the sides to fit more.
Because of the supports I had to sand the connection pieces to make it fit properly.
To build you need to print 1 Left Side, 1 Right Side, 3 Dice Holders, and the Plugs. The Middle piece is only used if you want to make the stand bigger.
After printed, follow those steps to build:
1- Fit all the Big Plugs on the Left Feet
2- Snap the Holders into the Big Plugs' holes.
3- If you want to make it bigger Snap the middle piece into the Holders Holes, and then snap more Holders.
4- Snap the Right Feet into the Holders.
5- Snap the Smaller Plugs into the Holders holes.
6- Make sure it's all properly snapped and that it's sturdy.
Dice_Holder.stl | 45.0KB | |
Dice_Holder_Big_Plug.stl | 27.2KB | |
Dice_Holder_Left_Feet.stl | 472.3KB | |
Dice_Holder_Middle.stl | 60.8KB | |
Dice_Holder_Plugs.stl | 125.8KB | |
Dice_Holder_Right_Feet.stl | 472.3KB | |
Dice_Holder_Small_Plug.stl | 14.8KB |