Modular Cable Guide 3D Printer Model
The file 'Modular Cable Guide 3D Printer Model' is (stl) file type, size is 248.6KB.
The file 'Modular Cable Guide 3D Printer Model' is (stl) file type, size is 248.6KB.
Are you in need of small cable ducts to hide away those anoying cables on or around your desk?
Look no further!
These cable ducts are 50mm wide which is more than enough for the usual amount of cables surrounding your desktop.
You can use this on top or below your desk, on your wall etc.
The straight is 158mm long. You can easily connect straights and bends just by sliding it into each other. The lid goes on with just a few clicks and can easily be removed by hand or by using a screw driver on the designated indentations.
I can add more lengths, widths later on or on demand.
[[The one you can see on the picture is a smaller test print to make sure the lid fits the bottom]]
UPDATE1:
I am going to add a cross and T-section later on to complete the set. Stay tuned!
UPDATE2:
Straight 140x30mm added on request.
Cross section 150x50 added
Files renames to accomodate sizes
| Bend.stl | 59.8KB | |
| Cross_150x50.stl | 90.5KB | |
| Straight_140x30.stl | 200.5KB | |
| Straight_150x50.stl | 217.7KB | |
| TopBend.stl | 157.3KB | |
| TopCross_150x50.stl | 166.2KB | |
| TopStraight_140x30.stl | 268.6KB | |
| TopStraight_150x50.stl | 291.9KB |
