This is a modular birdhouse that can be configured in multiple ways for many different types of birds and installation methods. Simply use the instructions below and pick the modules that you want to include for your birdhouse.
Each part is designed to print easily and without any support and minimum bridging. There are quite a few parts so check out the instructions for an overview of each.
I used the following links as references for how this birdhouse should be designed. There is a lot of useful information there so be sure to check them out too.
http://www.50birds.com/dbirdspecies.htm
http://www.squidoo.com/backyard-birding-dos-donts#module150675159
EDIT: I added some new concepts for an angled top instead of the flat top. The angled and the flat top are completely interchangeable. I also added a new extension concept. This 2 inch extender plugs into the normal bird housing to make it 8 or 10 inches (or any multiple of 2 really). It seems like a better idea than the original separate 8 inch housing. I did however decide to keep that housing as well since I already published it here. I also printed out a test of the pins and they worked surprisingly well. I was able to snap them together and open them, and they seemed like they would hold up well. Anyway, thats it for this update. I might add some more in the future if I find some time.
| BirdBath.STL | 475.2KB | |
| BirdFeederFaceBlank.STL | 2.2KB | |
| BirdFeederFaceOne.STL | 13.9KB | |
| BIRDFEEDERFACETWO.STL | 206.7KB | |
| BirdFeederPerch.STL | 4.2KB | |
| BirdFeederTop.STL | 5.9KB | |
| BirdFeederTwo.STL | 169.5KB | |
| BirdFeederTwoHalf.STL | 114.8KB | |
| BirdHouse6Inch.STL | 157.6KB | |
| BirdHouse8Inch.STL | 157.8KB | |
| BirdHouseExtension.STL | 13.6KB | |
| BirdHouseExtensionFace.STL | 1.4KB | |
| BirdHouseFace1.25.STL | 23.5KB | |
| BirdHouseFace1.5.STL | 23.5KB | |
| BirdHouseFace1.75.STL | 23.5KB | |
| BirdHousePerch.STL | 15.5KB | |
| BirdHouseTop.STL | 5.9KB | |
| BirdHouseTopThree.STL | 7.5KB | |
| PinFemale.STL | 49.8KB | |
| PinMale.STL | 39.9KB | |
| Planter.STL | 137.1KB |
