Modular Bathtub Tray/Organizer 3D Printer Model Free Download

Description Files (4)

Summary

This is a sturdy, easily accessible and infinitely extendable organizer for your bathtub corner with enough room to place all the shampoos, soap, gels and stuff for a whole family within reach where it's needed. It's also very printerfriendly with no overhangs and moderate printing time.

Print Instructions

Print "Tray.stl" for every lower tray
Print as many "Joint.stl" as needed to connect all the trays, one joint for two trays
Print "TOP_Tray.stl" for the top tray when using suction cups
Print "TOP.stl" for the endcap at the top

Important: print the parts oriented as shown in the slic3r screenshots. See "Print Settings" for how to setup your slicer software.

Assembly

Note: print with 0.2mm layer height to have the parts fit together just right with only little force needed. Once connected they won't come apart without some extra force applied.

Stick one "Joint.stl" into the top of the lowest "Tray.stl"
Push the bottom of one "Tray.stl" onto the joint. If it is the topmost tray and you want to use suction cups, use "TOP_Tray.stl"
Optional: put some silicon feet on the bottom of the lowest tray to allow water to flow out underneath
Optional: slide two suction cups into the slots of the "TOP_tray.stl" as seen in the pictures. The slots are 9mm wide
Put the endcap "TOP.stl" into the top tray

Joint.stl	453.3KB
TOP.stl	186.0KB
TOP_Tray.stl	553.3KB
Tray.stl	537.7KB