Modern Salt Shakers 3D Printer Model
The file 'Modern Salt Shakers 3D Printer Model' is (stl) file type, size is 6.3MB.
The file 'Modern Salt Shakers 3D Printer Model' is (stl) file type, size is 6.3MB.
A set of two ergonomic salt shakers, easy to grip and easy to pour. I say salt, because I prefer my pepper ground fresh, so I don't recommend anyone use pre-ground pepper ever! PSA: If you use pre-ground pepper, switch over now! The flavor difference is huge.
The holes are 2mm, that should be enough for a good pour, although you may need to use a poker needle to clear the holes fully after the print. The caps are sized to fit well, but if they're too tight, just twist them back and forth a few dozen times until they wear in.
The larger shaker allows a great deal of control over the amount of salting depending on its orientation, so whether you need to salt just a little or salt a whole table of barbecue quickly, it'll do the job!
The smaller shaker has a good pour, not as much control though, but a small foot print.
Recommended print settings: 2.8mm walls for durability and looks (this will make it solid, but still allow for infill in places like the cap body)
Warning: Print in a food safe material.
| saltshaker_large_body_final.stl | 5.5MB | |
| saltshaker_large_cap_final.stl | 1.8MB | |
| saltshaker_small_body_final.stl | 4.8MB | |
| saltshaker_small_cap_final.stl | 1.9MB |
