This is a three axis gimbal I have built many times over the last few years. It is simple to put together and for the most part bullet-proof. The parts list includes the following:
Prints
Mobius_Gimbal_Mount_Plate_v03.stl
Mobius_Gimbal_Side_Plate_01.stl
Mobius_Gimbal_Roll_Arm_v01.stl
Mobius_Gimbal_Yaw_Arm_v01.stl
Yaw_Motor_Base_v02.stl
Motors
3x RCTimer GBM2804 hollow shaft gimbal motors
Hardware
12x M3 x 8mm_SHCS
12x M3 Flat Washers
10x M3 x 6mm_FHPS
The dimensions of the printed parts are set to accommodate a Mobius with a C2 lens. The motors are a bit over-sized which is good if you are mounting on a plane. The motors also have a hollow shaft so that wiring can be neatly routed.
For a controller I would recommend the Storm32 3-Axis controller.
| Mobius_Gimbal_Mount_Plate_v03.STL | 309.6KB | |
| Mobius_Gimbal_Roll_Arm_v01.STL | 339.6KB | |
| Mobius_Gimbal_Side_Plate_v01.STL | 101.5KB | |
| Mobius_Gimbal_Yaw_Arm_v01.STL | 341.3KB | |
| Yaw_Motor_Base_v02.STL | 83.7KB |
