The file 'Mobile Phone Kickstand, Clip, Ring Holder, Protective Cover For Honor 20 Lite (or Others) 3D Printer Model' is (STL) file type, size is 943.3KB.
I designed a cell phone holder that slides on the cell phone with cover.
The special thing about this mount is that it not only looks cool, but because it is 3 mm thick it can also remain on the phone and does not have to be removed!
All switches and ports such as USB port, speaker port, volume, on-off are still accessible
With a hair dryer, you can heat the claws and "set" them tighter. But this only works with filament that can be bent after heating (no ABS)
The pins of the hinges are made of 1.75mm filament. It is advisable to use a well-adjusted printer for this purpose. Otherwise, the holes must be carefully re-drilled with a 2 mm drill.
Caution: the drill must not get hot, otherwise the part will melt and the holes will widen!
In order to let the holder fold down independently, a rubber band should be pulled into the grooves. I cut a piece of bike tube to 4mm wide, pull it through the opening and attach it to the outside with a small piece of filament
| aussen1.STL | 694.2KB | |
| kralle.STL | 797.9KB | |
| mitte.STL | 933.2KB | |
| ring.STL | 254.1KB | |
| Stuetze.STL | 88.9KB |
