Instructions: Open the box, and after placing the wires appropriately into the rotating knob, you can rotate the knob to collect the wires into the box.

The basis of this product is a box with a hinge, which, like the rotating knob, is one piece and does not require assembly. This design takes full advantage of the features of the 3D printer and does not require printing support.

When printing, the layer height is set to 0.15mm, and the fill density is set to 100%.

After printing is completed, please patiently loosen the hinge and the rotating knob. If necessary, you can add a little lubricant.

fix issue: 2024/4/2

1. in some cases, the box does not close all the way down issue,
2. in this version, improving the knob bottom side.

Update：2024/4/22

1. Improve the knob's bottom side again.
2. Strengthen the hinge's axis.