Mobile Cellphone Lying Booth Site 5吋手機座 3D Printer Model
The file 'Mobile Cellphone Lying Booth Site 5吋手機座 3D Printer Model' is (STL) file type, size is 246.7KB.
The file 'Mobile Cellphone Lying Booth Site 5吋手機座 3D Printer Model' is (STL) file type, size is 246.7KB.
It's an organic design, simple, light and easy for most tired mobile phone to lie.
Two angles for choose: 87' for raise sight & 60' for table leisure.
It's quite possible for lying a pad if you enlarge the scale.
Recommendation: 0.4~0.6mm width Fill 30% with Triangle,
0.6~0.8mm outer wall for a little bit flexibility.
No Need Supports.
Before you get to print it, pls turn the angle to drop the object on the plate.
Hope you enjoy it!
簡單化的有機設計手機架，輕盈方便使用。
可擺放將近垂直的87度方便遠看，還有60度角方便放在桌面上。
隨時讓你的手機有地方躺著看電影，或許放大一點也可以讓平板跟著躺。
建議填充使用0.4~0.6mm 線寬 作30%的三角形內部填充，
外壁用0.6~0.8mm厚度，讓它保持一點點的彈性。
不需使用支撐，請將物件擺正底部朝下，平放在床板上再切片列印。
希望你會喜歡。
| Phone_stand.STL | 714.9KB |
