I Designed this Frame because i couldn't find good fully Printable Frame for a 3D Printer.
List of Hardware to be used on this Design.
5 pcs Nema 17 Stepper Motor 17HS4401
2 pcs Threaded Screw T8x2 300 mm.
4 pcs 8mm x 400mm Y-Axis.
2 pcs 8mm x 370mm Z-Axis
2 pcs 8mm x 300mm X-Axis
2 pcs D19L25 Flexible Shaft Coupling
2 pcs GT2 20T Belt Bearing Pulley
2 pcs GT2 20T Belt Pulley
About 2 m of GT2 6mm Timing Belt
2 pcs 608ZZ Bearing ID 8mm
8 pcs LM8UU Linear Bearing ID 8mm
J-Head Extruder 0.4mm
Extruder aluminium block
Arduino Mega2560+Ramps 1.4+A4988 Stepper Motor Driver+2004 LCD Controller
3 pcs Mechanical End Stop
Proximity Sensor
The Bed Fit 214mm X 214mm Heated Bed.
( Optional ) Added Modular Extruder motor holder to be glued on base left or right.
| Base_Center.stl | 684.0B | |
| Base_Flaps.stl | 79.5KB | |
| Base_Front.stl | 141.4KB | |
| Base_Left.stl | 94.1KB | |
| Base_Plate.stl | 410.5KB | |
| Base_Rear.stl | 132.8KB | |
| Base_Right.stl | 94.1KB | |
| Extruder_Holder_2.stl | 92.9KB | |
| Extruder_Holder_2_with_Proximity_Holds.stl | 354.3KB | |
| Extruder_Holder_Linear.stl | 333.5KB | |
| Extruder_Motor_HolderOptional.stl | 68.5KB | |
| TopCenter.stl | 19.7KB | |
| TopRight.stl | 44.2KB | |
| Top_Left_Bowden.stl | 111.5KB | |
| X-Left_New.stl | 126.9KB | |
| X-Right.stl | 120.1KB |
