This is a cover for an indoor Blink security camera. Print the head in yellow, with the face down, no supports. The goggle can also be printed face down in silver, without supports. The black goggle band requires supports underneath the pin, and should be printed 2x. The blue body goes over the pan-tilt base, if you have one, also requires supports, especially around the G symbol. PLA should be fine for this model.
Only the goggle needs to be glued in. I used superglue.
| BASE_v2_BLUE.stl | 443.4KB | |
| goggles_silver.stl | 87.6KB | |
| goggle_band.stl | 41.1KB | |
| head.stl | 178.1KB |
