Minifigure Display Tube 3D Printer Model
The file 'Minifigure Display Tube 3D Printer Model' is (stl) file type, size is 54.4KB.
The file 'Minifigure Display Tube 3D Printer Model' is (stl) file type, size is 54.4KB.
This is a display tube I made to keep my figures safe while on display. The long pillars have 1/4" dowel rods inside. The length of these rods don't matter, you can just add more/less modules.
Each mini holder has a small slot for two locking bricks to be inserted. These bricks are meant to go over the base and keep the figures from falling out. The mini's ankles can sometimes get in the way, so there's also a smaller variant that might fit better. Worst case, you can always resize the brick to fit your figure.
There are also two washer files. The main one ("Washer") is shown in the picture. If you want a more compact version, the smaller one should still fit most figures.
The only difference between the base and cap is that the cap has openings to help pick up the display. I'd recommend gluing both of these to guarantee that nothing comes apart.
| Lock.stl | 684.0B | |
| Lock_small.stl | 684.0B | |
| Mini_Holder.stl | 119.1KB | |
| Tube_Base.stl | 24.7KB | |
| Tube_Cap.stl | 57.7KB | |
| Washer.stl | 25.1KB | |
| Washer_small.stl | 25.1KB |
