3D printed miniature filament spools. This is just a small project I did in between bigger projects. They ended up a bit cute and colorful so I decided to share them. This is a mix between high and low resolution FDM printing. I achieved the filament look by printing the filament at 0,4mm layer height, the spools themselves where done using best possible resolution. The spools are snap fit, but since I did not calibrate the printer profile between filament colors I used a dab of glue on few of them. This was an experiment too see how small I was able to make them, these are too small to work as keychain
Subscribe or follow me on:
Instagram: www.instagram.com/agepbiz
YouTube: www.youtube.com/user/agepbiz
Twitter: www.twitter.com/agepbiz
Best regards
Stian
WARNING: CHOKING HAZARD - Small parts
Not for children under 3 yrs.
| spool.STL | 122.7KB | |
| spool_filament.STL | 211.0KB |
