I've been looking for some nice looking stand for my minis and I've found one designed by ThomPerry63. It was designed for resin printing, and since I'm using mainly PLA I've tuned it to use it.
Changes:
Additionally I've designed three extension rings, if you want to fit 25mm, 28mm or 40mm base minis on it.
It still requires quite a lot of supports since it was primarly designed with resin printing in mind, but organic supports by Prusa did quite a good job (I had few stringing issues due to crappy PLA tho :))
Special thanks to Felipe and Zagomeza for help in design!
| extender25mm.stl | 172.2KB | |
| extender28mm.stl | 172.2KB | |
| extender40mm.stl | 172.2KB | |
| MiniStand_32mm.stl | 4.7MB |
