A panel mount housing for the small import LED voltmeter modules. The back of the case is a tight fit which retains the module without any screws, but there are also holes for small self tapping screws if you don't want the rear enclosed.

There is currently no provision for retaining the meter in a panel other than making it a tight fit or using self adhesive tape or glue behind the bezel, but I am planning to add a retaining clip.

Improvements over the original model from Arezus:
Removed the tiny pillars that retain the rear panel. I found these snap if you so much as look at them hard.
Reduced total depth as the rear panel fits flush with the back of the housing.
The module now fits more tightly up the bezel, the original was a little loose though my voltmeter module isn't exactly the same as the one they used.
Purely subjective but I found the bezel design a little old fashioned, the remix lhas a more modern crisp design.