Truck body and suspension prints in one piece. No need for support, supports are built into part. Rim caps friction fit to body, no glue is needed.
The print shown here was done with PLA using standard settings.
For a two-tone wheel ring, 19.8 mm is the appropriate height to swap filament if you are using a plugin to pause it.
Purchase some extra wheel designs and support my hobby
 | |
 |  |
| Body.stl | 294.3KB | |
| Body_No_Support.STL | 291.5KB | |
| Left_Wheel.STL | 332.9KB | |
| Right_Wheel.STL | 332.8KB | |
| Rims.stl | 329.0KB | |
| Wheels.STL | 1.3MB |
