I'm doing a little lathe for plastics. This is a work in progress and I will publish files and images when it is completed.
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
I'll add when I print out the newer versions. Observe what is going on. Be patient!
Chuck is reduced version published by bobwomble here:
http://www.thingiverse.com/thing:624625
Bobwombles profile:
http://www.thingiverse.com/bobwomble/about
| 3x_gear.stl | 3.8MB | |
| Back.stl | 2.1MB | |
| Flansh.stl | 385.0KB | |
| Front.stl | 3.0MB | |
| Gear_ring.stl | 1.2MB | |
| Jaw1.stl | 228.4KB | |
| Jaw2.stl | 233.2KB | |
| Jaw3.stl | 211.6KB | |
| Key.stl | 44.7KB | |
| Nosilec.stl | 451.3KB | |
| Nosilec1.stl | 379.0KB | |
| Nosilec_motor.stl | 369.5KB | |
| Nosilec_motor_sablona.stl | 262.1KB | |
| Nosilec_motor_zadaj.stl | 368.5KB | |
| Nosilec_pokrova.stl | 299.9KB | |
| Podstavek.stl | 156.8KB | |
| Pokrov_motorja.stl | 117.4KB | |
| reverse_jaw1.stl | 838.2KB | |
| reverse_jaw2.stl | 732.9KB | |
| reverse_jaw3.stl | 592.8KB | |
| Roka-kolo1.stl | 683.3KB | |
| Roka-kolo2.stl | 479.7KB | |
| roka-kolo_10_D.stl | 667.0KB | |
| roka-kolo_10_L.stl | 664.3KB | |
| roka-kolo_10_S.stl | 662.5KB | |
| roka-kolo_70.stl | 683.6KB | |
| Vjak_vodilo.stl | 122.7KB | |
| Vozek.stl | 176.9KB | |
| Vreteno_nosilec.stl | 135.1KB | |
| Vreteno_nosilec_zobnikov.stl | 641.1KB | |
| Vreteno_nosilec_zobnikov1.stl | 283.4KB | |
| Worm-jaw.stl | 1.0MB | |
| X-plate.stl | 409.7KB | |
| Zobnik.stl | 1.2MB | |
| Zobnik_spodaj.stl | 1.2MB |
