Modified insert for Minecraft Ore Lamp - quicker to print, with hole for small switch and cable.
Led strip can be placed around center base, and on top. Inside base can be mounted power supply or RGB controller etc. This part is screwed to the box with M3 screws up to 30mm long.
Inserts should be printed 5 times (for whole box) from some transparent filament, with infill (i set in Cura infill: Concentric 25% = best light transmision). They are the same, but rotated on each side.
| box.dwg | 159.9KB | |
| box.stl | 254.3KB | |
| wkladka.dwg | 76.4KB | |
| wkladka.stl | 1.0MB | |
| wkladki_przezroczyste.dwg | 62.7KB | |
| wkladki_swiecace.stl | 171.7KB |
