Milwaykee M18 Fuel Case Latch 3D Printer Model
The file 'Milwaykee M18 Fuel Case Latch 3D Printer Model' is (step,stl) file type, size is 179.8KB.
The file 'Milwaykee M18 Fuel Case Latch 3D Printer Model' is (step,stl) file type, size is 179.8KB.
Replaced Milwaukee(tm) M18 Fuel case latch with own version.
There is two versions to print. Other one has more support to be cut out.
In both versions "springs" need to be cut lose from the mark. This was small trade off to help printing it.
Recommend to print side down and with support.
This version can be taken off more easier than original one. Helps with the fitting and replacing latch, if it breaks again.
How I took old latch out: Put screw driver to gap under latch and gently press crew driver down and then pull latch up until latch comes lose. Be careful not to break the original plastic on the case.
| Milwaykey_M18_case_latch.step | 381.9KB | |
| Milwaykey_M18_case_latch.stl | 65.3KB | |
| Milwaykey_M18_case_latch_with_more_build_in_support.step | 448.9KB | |
| Milwaykey_M18_case_latch_with_more_build_in_support.stl | 91.3KB |
