Milwaukee M18 Magnetic Bit Holder 3D Printer Model
The file 'Milwaukee M18 Magnetic Bit Holder 3D Printer Model' is (step,stl) file type, size is 360.2KB.
The file 'Milwaukee M18 Magnetic Bit Holder 3D Printer Model' is (step,stl) file type, size is 360.2KB.
I wanted a bit holder that could hold at least 3 bits and not stick out too much or interfere with my hand while holding the drill.
Model A - Recessed mounting point that works with many Milwaukee M18 tools but not all.
Model B - Planar mounting point that works with any tool.
For best results, press four 5mm diameter by 3mm thick magnets into the slots on the backside. ¼ inch driver bits will be held with interference-fit, and smaller drill bits will stick to it with magnets.
Print with PETG, or ABS/ASA at 0.15mm layer height, no supports needed. PLA will work but may become loose over time. Model A has built-in supports that you can remove with flush cutters.
Made with FreeCAD.
| MilwaukeeBitHolderA.step | 271.9KB | |
| MilwaukeeBitHolderA.stl | 602.1KB | |
| MilwaukeeBitHolderB.step | 217.0KB | |
| MilwaukeeBitHolderB.stl | 86.5KB |
