-Use 10-32 heat set inserts - .25in length (6x)
-Use 10-32 button head cap screw 1.25in length (4x)
-Use 10-32 button head cap screw .375in length (2x)
-Passive locking tab to maintain angle
Steps to remove the lifecam rubber tongue
(1) removing 2 front cover screws on the sides of tongue from backside - look down into the visible cavity
(2) remove front cover
(3) remove 2x screws on PCB and move PCB to the side
(4) pry down on dowel c-clip on bottom side of camera with flathead screwdriver. Remove dowel from top side, shake it out of the housing.
(5) pull out tongue
(6) reassemble 2x pcb screws
(7) reassemble 2x front cover screws
| HatchPanelCameraMount_Housing.STL | 855.0KB | |
| SingleCameraCover_wLightRing.STL | 1.3MB | |
| Swivelbase_HatchSide_Vision.STL | 2.1MB |
