I loved the MicroSD Card Holder made by bgill, but some MicroSD cards are thicker than others and some cards would jam. My solution was to make the existing model a bit bigger so that the card would go in (and out) a lot easier. The cards will all fall out if it is turned upside down, which is why you use the lid!
The black dot on the top was done with a felt pen, so that I knew which way up to hold it to locate a specific card.
| microsdcardholderbot.stl | 593.6KB | |
| microsdcardholdertop.stl | 874.9KB |
