This is a rebuild/remix of the Micro SD Card Holder from bgill.
I basically gutted his uSD card slots as they seemed a bit too tight. I also slightly enlarged the cap threads and added a mild taper to the cap threads to make the cap easier to thread on if there are any irregularities in the print.
I provided a 16x uSD card model and a larger model that holds 6x SD cards and 2x uSD cards. Both uSD and SD holder bottoms expect the standard cap. If you use the large cap, the cards will rattle around needlessly. The extra large cap will allow the uSD cards to fall out of their slots.
In addition, I created generic open containers with both flat and rounded bottoms and two extended caps for general use holding screws or whatever loose stuff you got laying around. The rounded bottom ones make getting small items out easier. There are 3 depths of bottoms, standard, large and extra large. There are also 3 sizes of caps, standard, large and extra large.
The caps are shown and modeled right side up, you should 180 them so the top of the cap is against your print bed for printing (hollow facing upwards).
Note: I have also included a solid bottom piece that you can easily boolean out of to make whatever specific container you need.
| BaseNewFilled.STL | 492.5KB | |
| BaseNewOpen.STL | 567.5KB | |
| BaseNewOpenLG.STL | 567.5KB | |
| BaseNewOpenRounded.STL | 717.5KB | |
| BaseNewOpenRoundedLG.STL | 717.5KB | |
| BaseNewOpenRoundedXL.STL | 717.5KB | |
| BaseNewOpenXL.STL | 567.5KB | |
| BaseNewSD.STL | 536.4KB | |
| BaseNewUSD.STL | 564.7KB | |
| CapNew.STL | 812.2KB | |
| CapNewLG.STL | 874.1KB | |
| CapNewXL.STL | 874.1KB |
