Microphone Desk Boom 3D Printer Model
The file 'Microphone Desk Boom 3D Printer Model' is (STL) file type, size is 4.5MB.
The file 'Microphone Desk Boom 3D Printer Model' is (STL) file type, size is 4.5MB.
This is an almost fully printable microphone desk boom. The non printed hardware needed is:
•2X Hex Head Screw 1/4"-20 Thread Size, 1-1/2" Long (7/16" Hex)
•2X Nylon-Insert Locknut 1/4"-20 Thread Size (7/16" Hex)
I ended up not using the screw caps and instead used real tools to tighten the bolts as it was too difficult by hand.
To assemble:
1) Insert post into clamp and secure with post key.
2) Press fit post extender into the first post if additional height is desired
3) Assemble the rest of the setup according to the provided pictures
| Bar_Connector.STL | 604.8KB | |
| Clamp.STL | 268.5KB | |
| Clamp_Screw.STL | 4.8MB | |
| Connecting_Screw_Long.STL | 965.9KB | |
| Connecting_Screw_Short.STL | 1.1MB | |
| Long_Bar.STL | 30.3KB | |
| Mic_Holder.STL | 382.4KB | |
| Mic_Holder_Interface.STL | 351.4KB | |
| Post.STL | 57.9KB | |
| Post_Extender.STL | 70.0KB | |
| Post_Key.STL | 168.9KB | |
| Printed_Nut.STL | 260.9KB | |
| Screw_Cap.STL | 1.0MB | |
| Slide.STL | 112.3KB |
