Micro VTail Quadcopter 3D Printer Model
The file 'Micro VTail Quadcopter 3D Printer Model' is (stl) file type, size is 7.2 MB.
The file 'Micro VTail Quadcopter 3D Printer Model' is (stl) file type, size is 7.2 MB.
I've always been a sucker for different looking multirotors. After designing bigger frames I decided it was time for something smaller so I came up with this small (120mm MTM) brushed vtail quadcopter.
It's designed to use Beef's Brushed Board but will fit any FC with the dimensions 32x32mm or smaller. The frame only fits brushed 8.5mm motors.
My setup is a bit on the heavy side. 75gr AUW with a 500mah 1S battery. It's not an acro frame...
Let me know I you have any questions and I'll try to answer them.
And please respect the licence...
| MicroVTail_Canopy.stl |
| MicroVTail_Canopy_with_antenna_and_lens.stl |
| MicroVTail_Canopy_with_lens.stl |
| MicroVTail_Frame.stl |
| MicroVTail_Frame_v2.stl |
| MicroVTail_Front_foot.stl |
| MicroVTail_Rear_foot.stl |
| MicroVTail_Skirt.stl |
| MicroVTail_Skirt_with_lens.stl |
| MicroVTail_Skirt_with_vents.stl |
| MicroVTail_Skirt_with_vents_and_lens.stl |
