My Anet A6 has a poorly positioned Micro SD card reader, which is on the main board and hard to get to... so I purchased a 25cm extension cable and wanted to mount the new card reader at the top of the printer.
I've uploaded the right side bracket (same as the original, but just the single bracket), to use on the right side of the filament feeder bar.
Please see the original filament feeder (I remixed this from) for the brackets without the card reader. http://www.thingiverse.com/thing:1780416
As I already had a specialized bar running across the top of the printer to allow easy feeding of filament, I simply modified one of those brackets to make it perform 2 functions.
I designed some supports into this design... they're very small... it printed successfully without additional supports, but were I to make them again, I'd make the supports within my design a little larger.
As noted in my comment (reply), I bought my extension cable direct from China... it took 2+ weeks to arrive, but was very inexpensive with free shipping.
This is showing 60cm, but I'm pretty sure mine was 25cm and was sufficient).
| A6-3D-FilamentFeedBrackets.123dx | 136.6KB | |
| A6-3D-FilamentFeedRightBracket.stl | 120.3KB | |
| CardReaderBrkt.123dx | 308.1KB | |
| CardReaderBrkt.stl | 1.2MB |
