Bought a Micro SD card extender from AliExpress (as the one in the MPSM is kinda fragile) and the other designs were not what I was looking for, so I made my own.
Printed with Hatchbox PLA, it requires the following hardware:
Mounts using the existing screws, just unfasten them one at a time, present the holder and fasten again, then repeat.
You will need one of each piece (1x base + 1x cover), no supports or rafts are required.
Once printed just apply the brass inserts with a soldering iron on minimum heat.
The only issue is routing the ribbon cable for the extender, currently I only ran it from below the printer body, but I'm pretty sure a more elegant solution exists.
| micro_sd_holder_base.stl | 55.6KB | |
| micro_sd_holder_cover.stl | 19.0KB |
