3D printable micro quad frame that in my case, uses mostly Eachine QX90 hardware. It has plenty of room on board. I am using Easchine EF-01 FPV camera, 55mm propellers and 8.5x20 motors. Motors are mounted with regular rubber grommets, outside diameter 10mm and inside 8mm. Or you can use same that are used on QX90.
You can choose between two versions of top decks. The longer one holds EF-01 camera safely in place. Shorter one just gives some free space in front of quad if you use different camera. To fix top deck in place I just used four 12mm regular plastic stand-off, if 3d printed they may be little too brittle and I had them laying around, but I added file for them too, so you can print them (no thread inside, just 3mm hole).
| frame_v2.STL | 148.5KB | |
| standoff.STL | 8.7KB | |
| top_deck_long.STL | 79.2KB | |
| top_deck_short.STL | 52.8KB |
