On popular demand: This a new canopy for toothpick & whoop style frames that will fit most regular 19mm micro cams.
Check my other posts for the 3D printable toothpick style frame and Pod for the Caddx EOS2 and the Runcam new Runcam Nano

Recommended Setup

• FC+ESC: Crazybee F4 pro
  Update: Please don't get the board with the integrated receiver. It's horribly unreliable and has the worst range I have ever seen. Get the r-xsr if you run FrSky or any other small RX that fits your radio. Btw you can hook up an external receiver even to the Carzybee with the integrated RX. To protect the 5V regulator and have a cleaner power supply I soldered a 1000uf 10V Elko to the XT-30 connector and I had no issues at all after at least 60-70 packs. The GEPRC 12A looks really promising too! It's supposed to be 4S capable and 12A enough by a huge margin! I have ordered one that I will hopefully be testing soon.

• FPV Camera: Caddx Turbo EOS 2 20% off coupon for the caddx: 8765c2

• Motors: Amax 1103 7500kV

• Budget Motor Option: Racerstar 1103 8000kV

• Video Transmitter: TBS unify nano TBS Nano knock-off

• Batteries: 450mah Battery

• Misc: XT30 connectors

• Props: King Kong 65mm

• Pod: Gatehunter Canopy

• Transmitter: I use the [FrSky QX7(https://www.banggood.com/custlink/mvvDheJmM6) with upgraded hall gimbals

• FPV Googles ($50): Eachine EV800
  the ev800 is enough to start flying. The screen quality is actually pretty good. And when you get Fatshark later you can keep the ev800 as a spectator google or detach the screen

Other small stuff you need: 1.45mm drill for the props. 12mm M2 screws & a tiny LiPo strap (unfortunately Amax doesn't seem to make them anymore). Else you can just use a rubber band to strap the LiPo to the frame.

Detailed build guide by Kabab FPV

My Printer is a Creality Ender 3