Sewing EDC set in micro size.
The coil contains 3 sections for threads, each of which is wound up to 5 meters of thread. This is more than enough for emergency repairs. Also, you can wind the thread into 3 sections at once without breaking the thread. The sewing threads can be wound smoothly with a screwdriver.
The central section of the coil accommodates 2-3 needles up to 60 mm long.
The threaded cap has a recess, so that the cap can be used as a thimble.
Printing recommendations:
Layer height - 0.1mm
Seam position:
on the coil - random
on the threaded cap - random
on the outer cover - as you wish
When printing the coil, turn on the combing (avoid crossing perimeters), otherwise you may need to drill the needle compartment.
I also have a larger sewing kit:
https://www.thingiverse.com/thing:6416831
Subscribe.
| Cover.stl | 40.0KB | |
| screw.stl | 191.2KB | |
| Spool.stl | 261.7KB |
