MGTF MGF Subframe Hole Covers 3D Printer Model
The file 'MGTF MGF Subframe Hole Covers 3D Printer Model' is (stl) file type, size is 1.7MB.
The file 'MGTF MGF Subframe Hole Covers 3D Printer Model' is (stl) file type, size is 1.7MB.
These caps block holes in the subframe of my MGTF to keep out weather elements and hopefully prevent water ingress and subsequent corrosion. I printed them in Eryone TPU which is the cheapest I've found on Amazon at the moment.
For the rear subframe, there are two Stadium shaped, two Round Large (47mm OD) and six Round (38mm OD) caps required; only two Round are required if not covering four holes in the cross member.
The Chorded model is used to fill the holes used to attach straps or tow ropes for securing the car.
| Subframe_Hole_Cap_Rectangle.stl | 578.4KB | |
| Subframe_Hole_Cap_Round.stl | 1.1MB | |
| Subframe_Hole_Cap_Round_Large.stl | 1.1MB | |
| Subframe_Hole_Cap_Round_Large_Chorded.stl | 1.3MB | |
| Subframe_Hole_Cap_Stadium.stl | 1.3MB |
