If you like this original print, donations are appreciated, but optional :) www.paypal.me/ahplua

07-12-2024 - V3: I got a new water bottle now, even larger than the previous. So i updated the model, and simplified it since i didn't like the complexity of the V2.

V3 is mostly small changes from V2, with the main difference being a larger main cup holder and a simplified single insert (Make your own, or comment if you want more sizes. See below for diameter to make your own)

✅V3 - Even better fit! Now we are reaching almost perfect fit, there is close to no wiggle now.
✅V3 - Attached feet! The feet at the bottom are now attached for simplification, printing them separately in V2 was bad design.
✅V3 - 19cm diameter main cup holder (Made for the 946ml/32oz Hydro Flask Wide Flex Straw)
✅V3 - New simple 330ml insert (Untested). This uses a bit more filament, but is as simple as it can possibly be, the old complex system was over engineered.
✅Print flat upside down, for a nice finish on the top of the cubby. Use a texture print plate for extra finish!
✅Low height so you can close the sliding door in the middle console over it.
✅No supports or overhangs.
✅(Relatively) optimized design, for minimal filament use.

❗Please note that there is two different bottoms. A standard "MG4_Cubby_v3_bottom.stl" which is the same diameter as the hole and a "MG4_Cubby_v3bottom+0,2.stl" which simply is 0,2mm larger diameter for a extra snug fit. I printed this with a standard 0,4mm nozzle and the standard one was a bit loose for me since i wanted it to fit really snug, so it doesn't fall out, so the +0,2 diameter is the one that worked best for me. Your printer, material, and settings may vary, so start with the standard one if you don't know your printers tolerances. Scale if needed if neither bottoms fit for you.

❗All the inserts for the large cupholder are untested, comment below if they work or not and i will change them and add more.

The "MG4_Cubby_v3_33cl_insert.stl" is a simple insert that goes in the large cup holder, to make both cup holders fit a standard 33cl EU can, so they're the same size if you don't need the XL cup holder.

The exact diameter for the large cup holder, is 190.54mm. You can use this to print your own inserts if you want, or drop a comment if you want me to make different diameter inserts.

Please comment with any issues or suggestions :)