Meshtastic Pro And Ultimate Solar Radio Nodes 3D Printer Model
The file 'Meshtastic Pro And Ultimate Solar Radio Nodes 3D Printer Model' is (stl) file type, size is 1.9MB.
The file 'Meshtastic Pro And Ultimate Solar Radio Nodes 3D Printer Model' is (stl) file type, size is 1.9MB.
This is a set of files to make a complete Meshtastic Pro or Ultimate solar node.
To make them, you will need to print one of the Main Body files, depending on if you want to use an SMA or N-Male antenna base. Then you need to print a panel base to match whatever solar panel you want to use. I'm including three sizes, which are fairly easy to match. You'll also need a double 18650 or 21700 battery holder, a solar charge controller, and a rak wireless 19007 or 19003 meshtastic starter kit. You need to print the Cover, the gasket and the switch cap as well. It's a lot of parts and filament. Save time and just order a complete one on my etsy store :)
I use my Li-Protect battery protection boards and an mppt solar charge controller in the ones that I sell, which would be the best way to make sure these work properly.
Printed in ASA, flat side down. Supports definitely needed
Please post pics if you make one, check out my other designs for more fun ideas, and you can purchase these assembled and tested on my etsy store at
https://magicgrowingshop.etsy.com
Thanks!
| Meshtastic_Pro_Solar_100x100_base.stl | 217.0KB | |
| Meshtastic_Pro_Solar_110x80_base.stl | 315.9KB | |
| Meshtastic_Pro_Solar_163x93_base.stl | 119.7KB | |
| Meshtastic_Pro_Solar_Cover_V2.stl | 144.9KB | |
| Meshtastic_Pro_Solar_Gasketthick.stl | 1.1MB | |
| Meshtastic_Pro_Solar_Main_Body_N_Male_Thin.stl | 2.3MB | |
| Meshtastic_Pro_Solar_Main_Body_SMA_THIN.stl | 1.7MB | |
| Meshtastic_Pro_Solar_Switch_Cap.stl | 63.7KB |
