Case for my DIY Meshtastic device. It is not mention for some official board (but maybe some will fit), it is for custom Meshtastic device. I have used ESP32, LoRa module (Ra-01 LoRa SX1278 433M, frequency will depend on your region) and SSD1306 OLED display. I just wanted test Meshtastic so maybe it will come handy for someone too:)
I have cretaed battery case as well so it is fully portable.
I have used 7.4V 1100mAh Li-Po battery and step down module to decrease voltage for ESP32 to 5V (connected to Vin pin).
I have printed with White and Green PLA for nicer look.
Modules used:
For battery case:
BambuLab X1C
0.2
20 infill
PLA+
no supports
| antenna_holder.stl | 195.6KB | |
| battery_case_bottom.stl | 438.0KB | |
| battery_case_switch_holder.stl | 64.7KB | |
| battery_case_top.stl | 424.1KB | |
| logo.stl | 181.9KB | |
| lora_holder.stl | 91.0KB | |
| Meshtastic_case_bottom.stl | 736.4KB | |
| Meshtastic_case_top.stl | 169.1KB |
