Medium Lightweight Bookend 3D Printer Model
The file 'Medium Lightweight Bookend 3D Printer Model' is (stl) file type, size is 7.8KB.
The file 'Medium Lightweight Bookend 3D Printer Model' is (stl) file type, size is 7.8KB.
Medium-sized lightweight bookend inspired by xyzaxis's Lightweight Bookend.
Similar design ideas as xyzaxis's bookend: simple, low-filament usage, thin part that goes under books.
The bottom of the vertical portion is not attached to the bottom, which removes a strain point where it would otherwise fail under heavier load.
Prints with a small brim at the skinny end to decrease the chance of peeling off the bed; use a nail-clipper to clip it off after printing. Suggest using a high-adhesion bed like PEI.
| Bookend_medium_mk1_final.stl | 39.6KB |
